Orion-system VCM-X/RNE Controller Uživatelský manuál stáhnout pdf (Strana 35)

VCM-X / RNE Operator Interface SD

RNE CONFIGURATION

RNE Conﬁ guration Screens

Conﬁ guration Screens

In order to correctly set up the RNE Controller, you must ﬁ rst conﬁ gure

several parameters in regard to the type of HVAC unit and system you

have installed. Most of these values and operating parameters are only

set once at the initial system setup and are never changed.

Modular Service Tool SD Instructions

No matter what screen or menu you’re in, press <CONFIGURATION>.

The Unit Selection Screen will appear, shown below, requesting that you

enter the unit ID number.

Unit Selection

Enter Unit ID#

Selected ID#: XXXX

*00*

Enter the correct unit ID number of the RNE Controller you want to

conﬁ gure and then press <ENTER>. You must type in the number, even

if it is “1”. Once communication is established, the *00* at the bottom

will disappear. Then

press <>. You will then see Unit Conﬁ guration

Screen #1. Press

<ENTER> to save entered data and press <> to

scroll through the screens.

NOTE: If the *00* remains, it indicates a communication failure

to the controller.

System Manager SD Instructions

From any Main screen, press <SETPOINTS>. The screen below will

appear because this option requires passcode clearance. Only a Level 2

passcode can change setpoints.

THIS ACTION REQUIRES

PASSCODE CLEARANCE

Enter Passcode: XXXX

If the correct passcode was entered, the Unit Selection Screen will be

displayed.

Unit Selection *00*

Enter Unit ID#

Selected ID#: XXXX

Enter the Unit ID of the controller you wish to change schedules for

and press <ENTER>. You must type in the number, even if it is “1”.

Once communication is established, the *00* at the top will disappear.

Then

press <>.

NOTE: If the *00* remains, it indicates a communication

failure to the controller.

The following screen will be displayed:

Change Setpoints

Configure Unit

Save/Copy/Restore

Scroll down to the ‘Conﬁ gure Unit’ option and press <ENTER>. This

will take you to the ﬁ rst Conﬁ guration Screen shown below.

Conﬁ guration Screen #1 - Duct Static

Pressure

RNE Cnfg ID 101

Duct Static Pressure

Control: YES

Use < Or > To Change

If the HVAC unit has a Supply Fan that delivers a Constant Volume

of air, select NO. If the HVAC unit has a Supply Fan that delivers a

Variable Volume of Air using a VFD or a Bypass Damper, select YES.

Default is YES.

Conﬁ guration Screen #2 - Supply Fan Cycle

RNE Cnfg ID 101

Supply Fan Cycle

Mode: NO

Use < Or > To Change

If you want the HVAC unit’s Supply Fan to run during Heating, Cool-

ing, or Dehumidiﬁ cation Modes, select YES. If you want the HVAC

unit’s Supply Fan to run continuously while in the Occupied Mode,

regardless of the Heating, Cooling, or Dehumidiﬁ cation Modes, select

NO. Default is NO.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 91 92

Komentáře k této Příručce

Žádné komentáře

Orion-system VCM-X/RNE Controller Uživatelský manuál Strana 35

Komentáře k této Příručce

Související produkty a manuály pro Hardware Orion-system VCM-X/RNE Controller