Orion-system Lead Controller Uživatelský manuál Strana 8

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 56
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 7
Zone
Zone
Section 1: Lead/Lag Wiring & Setup
Lead/Lag Controller Technical Guide
8
Controller Addressing and Baud Rate
The Lead/Lag Controller is equipped with address switches. When
using Prism 2 to program and con gure the Lead/Lag Controller,
you would enter this address to communicate with the controller.
When the system is to be connected to other HVAC unit controllers
on a communication loop, each controllers address switch must be
set with a unique address between 1 and 59.
Figure 4: Lead/Lag Controller Address Switch Setting
Address switches 7 and 8 are used for the baud rate selection. See
Figure 4 below for baud rate setting information.
Addressing and Baud Rate Settings
Zobrazit stránku 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Komentáře k této Příručce

Žádné komentáře